Delicious gołąbki 🤤

Sowas kann nur von einem kommen der gar nicht zur Arbeit erscheint

https://www.spiegel.de/politik/deutschland/markus-soeder-nimmt-nur-selten-an-bundesratssitzungen-teil-a-7e5d521d-91e6-4d01-91fd-57d70bf519f8

„The goat is lying!!!“

I tried to get the US-Citizenship. But then came the Macarena…

Wenn der Schmutz gleichmäßig verteilt ist sieht das Ganze gewollt und nicht mehr nach Schmutz aus 👍

Can’t read anything, this picture is too sharp!

What do you think of DD/HH/YYYY/Min/MM/Sec?

But your application will be sorted out beforehand when it’s written by an AI 🤮

Some years ago I’ve been to a blink182 open air concert with a girl I liked. And just when the chorus of the song „always“ started, warm Summer rain began to fall. It was amazing!

I can feel when lights are turned on or shine at me. Taking photos with a flash for example feels like a hot wave to me. I think that is a side effect of my ASD, the poor stimulus filtering to be exact

Also I can hear most electric devices because of that. Charging them for example has a loud high frequency noise. Not just cheap chargers, almost all electronic devices

Imagine they did this that way: „hey Bob, I’ve some good and some bad news for you. The good one fist: you got promoted to Manager/VP/Whatever. The bad one: in order to make the company more efficient we’re letting go of some higher staff. So, you’re fired. Pack your stuff and fuck off until 12pm, manager Bob!“

You could go out on a date with me to make it round 😘

Philadelphia Collins ❤️

And uber be like: Kenya… Stop doing this plz

Spaßbremsen…

Pollockbot - 3000

I don’t believe in fish. They‘re just actors hired by the government. Wake up, sheeple!

Checkmate!

I just posted the update as an edit of this post.

Thank you again for the help and the links, that was really helpful while troubleshooting!

Thank you for your answer!

Have you verified that the power supply wiring is correct? Red = + Black = -. I have had supplies where the red and black were reversed during manufacture, I have also had led strips where the labeling was reversed.

I have not, that’s a good point! I‘ll see if I can find a way to Check that.

Is the arduino getting power in this situation? It looks like it is only connected to data and ground. I have no experience with arduinos, but I would think you would have 3 wires connecting to it. +, -, and data.

I disconnected the cables when making the picture, so you can see the wiring I soldered. I connected +5v with the red wire of the power supply, data with pad5 on my arduino and ground to the black wire of the supply and ground on the arduino.

You say 12v for the lights, but input on the strips says +5v

The supply was already in work as an ambulatory supply before, i just got new LED strips with even more LEDs (got a new, bigger screen). In the online Tutorials they also use 12v supplies. Unfortunately I have no weaker ones to try out